TM 5-4220-226-14&P
3-2. Maintenance and Reentry Control Procedures - continued.
(3)
2407 Control NR: (Attach 2407) Taken from the DA Form 2407, upper left-hand comer.
(4)
UIC: Unit Identification Code.
(5)
SYSTEM: Superlite 17B Diving Helmet.
(6)
SUB-ASSEMBLY: The portion of the system that is being worked on.
(7)
COMPONENT: The part of the subassembly that will be fixed, i.e., gage isolation
valve, etc.
(8)
S/N: Subassembly serial number.
(9)
P/N: Component part number.
(10)
FAULT ANALYSIS PERFORMED: (Describe Problem) Describe the problem and any
special procedures used to isolate the problem.
(11)
ACTION TAKEN: (Check One)
TEST:______ADJUST:______REPLACE:______REPAIR:______OTHER:______
Check the appropriate maintenance action.
(12)
MAINT LEVEL: Enter the single element maintenance code IAW the MAC.
(13)
WORK TIME: HRS. Enter the required time to complete the task (hours and tenths).
(14)
WORK DESCRIPTION: Describe the procedures used to perform the required
maintenance.
(15)
OLD COMPONENT DISPOSITION: What did you do with the old part (i.e., disposed,
turned Into general support for repair, etc.).
(16)
WAS SYSTEM INTEGRITY COMPROMISED? YES_____ NO_____ Check
appropriate box.
(17)
IF YES, CLEANING PROCEDURE USED: Enter the cleaning procedure used.
(18)
WAS AIR SAMPLE TAKEN? YES_____ NO_____
ANALYSIS RESULTS: Check appropriate box and enter the analysis results.
(19)
REENTRY CONTROL LOG COMPLETED: (Initial) Enter initials after log entry is
made.
(20)
WORK PERFORMED BY: Enter name, rank, title of person performing maintenance.
(21)
WORK CHECKED BY: Enter name, rank, title of person performing check.
3-2
