TM 5-4220-225-14
6-5. Umbilical (Cont).
(ad)
After connector cools, install new preformed packing (12) in groove of connector (13).
(ae)
Apply halocarbon grease to connector pins.
(af)
Slide boot (11) over soldered pins and seat boot (11) on bottom of connector (13).
(ag)
Apply a light film of lubricant to outside of pin connector.
(ah)
Slide connector nut (14) onto shell (15).
(ai)
Install new preformed packing (16) in groove in shell (15).
(aj)
Place two tube spaces (10) around cable, ensure bottoms fitting into
outer rim of support tube (7) and tops
fitting under edge of pin connector boot (11).
(ak)
Aline key of connector (13) with keyway in shell (15).
(al)
While holding tube spaces (10) around wiring, slide shell (15) over connector boot (11) until pin (16) seats
in hole in support tube (7).
(am)
Ensure shell (15) and boot (11) are installed completely so that they do not turn.
(an)
Install two retainer halves (17) on shell (15) and slide connector nut (14) down to secure then in place.
(ao)
Tighten connector nut (14) and secure by tightening setscrew (18).
(ap)
Remove cable (1) and cable chuck from vise.
6-18
