TM 5-4220-225-14
6-5. Umbilical (Cont).
(x)
Remove cellophane cable filter and separate wires as follows: two twisted shielded pairs (one white one
black) in black shielding and one in white (both pairs wrapped in shielded woven wire), two twisted sets of
three wires (one white, one black and the other red or green), and four single wires, one black, one white,
one green, and one red.
(y)
Check red-white-black triple wire for continuity. If these wires do not check out check the green-white-
black set.
(z)
Cut off the set of wires that will not be used along with the four single wires.
(aa)
Unbraid the shielded woven wire and solder to one of the spacer tubes (10).
(ab)
Install pin connector boot (11) over cable wires.
6-14
