TM  5-4220-231-14.&P 5-17.   Low    Pressure (LP)    Hose Assembly. See Figure 5-16. This   task    covers: Repair INITIAL   SETUP Tools General Mechanics Tool   Kit Hose, Clamping Tool Materials/Parts Reference Hose     Assembly, LP,   4  foot,    13229E4656-1 Para.     3-13    Maintenance and     Reentry Control     Procedures Hose    Assembly, LP,   10  foot,    13229E4656-2 Antiseize Compound (Item   8,  Appendix D) Silicone Compound (Item   9,   Appendix D) Nonionic     Detergent Solution     (NID)   GP (Item   17,   Appendix D) Clamps, 4730-01-014-1078 End   Connectors. 4730-00-369-4589 NOTE Perform in  a  clean environment. a.   Disassembly Instructions (1) Remove washer (4)  from   end    of  barb (5)  in  the    end   fitting   assembly. It only   the   washer (4)   is  to   be replaced, proceed to   and install IAW   stop    b.1. (2)    Cut   the hose (2)   three inches from    the    clamp (7)   which is  farthest from   the    end of  the hose. Remove and   discard the   three clamps (7)   from   the   cut   sectors of  the   hose (2).   Remove barb (5)   from   hose. Remove nut   (6)   from   barb (5).    Remove washer (4)  from    barb    (5).    Discard damaged or   unusable parts. (3)    Bag and retain usable parts. b. Reassembly Instructions (1) Lubricate washer (4)  with   silicone compound (Item    9.  Appendix D),  and install   in  end   of  barb    (5). (2)    Reassemble hose assembly, by   positioning nut   (6)   over barb (5).   Lubricate barbed end of  brass barb (5)   with   silicone compound (Item    9,  Appendix D),  and insert    into   hose (2). (3)    Secure end    fitting   to   the hose end    by   means of   three clamps (4)   staggered at   120   degrees. Tighten each clamp until   it  depresses the    hose about 1/16- inch at   each side of  the    clamp. Change 5 5-67